3D Printer Glue Stick 6 Pack, Perfect First Layer Adhesion, Prevents Warping on Heat Bed, Easy Release for ABS PLA PETG Filaments and Various Build Plate, 36g/1.27oz

This glue stick worked well on my ender 3d printer. The material is PVP (Polyvinylpyrrolidone). It has a slight odor which quickly fades as the bed heats up. So far it holds solid while printing PLA and TPU. This order included 3 glue sticks. They are the larger 3/4 inch diameter size. This will last me a long time. It applies smoothly without gooping up the bed. Excess glue cleans up easily with water. This has cured my prints pealing up at the corners. I have other glue sticks that have worked and some that have not worked. This one has so far worked the best of any I have used. I did read that it does not work with PLA+ material.I want to add to my review of this product. I have a roll of polypropylene filament that has been on my shelf for two years. It prints fine to itself but I could not get it to stick to the build plate. I just tried it with this PVP glue stick and it is working for me. The part I am making is small only 1.5 inch diameter but I could not even do that before. polypropylene is nice for living hinge applications. It is very chemical resistant and higher temperature than PLA. One more reason to like this glue stick.

I was almost about to give up on trying to get prints to stick, that was until I bought this stuff. Now I bought 2 more printers and couldn't be more happier. This stuff works really good and through multiple prints. It shouldn't be a factor, but I really like the lemon smell as well.

Works great with my 3d printer. Only ones I found that do.

Works

Works good.but just get cheap glue like Elmer's they work the same

I used to buy regular glue sticks from Walmart and these were less expensive and made it so I didn’t have to go into Walmart. The adhesive holds enough that the print doesn’t move, but doesn’t make it difficult to take your print off when it is completed. The glue quality is high and good and is very inexpensive. It is super easy to use, open the cap, twist it up, use it, twist it down, put the cap back on. Super easy!

I use this on my Bambu labs x1 carbon with the textured PEI sheet and it works perfect. Holds the part down and is easy to clean up.

Very good glue. Sometimes it is a bit too strong for my projects so need to be mindful on how much you use depending on the application.