Size:F54 F55 F56 (Gen3)  |  Color:Usa flag About Install: Please note that before you install, make sure that the surface is clean and free of grease. After the installation is complete, be sure to bake with hot air gun  (to soften the adhesive material, enhance the adsorption) No completion of these two steps, it is possible in a very short time, the sticker will lose its sticky. About Material: This Kind of Material PVC, Have Flexibility,  There might be a little bit of change Depend on the Weather So the size may Have Litter Error of 1-2CM difference. About packaging: We will first use wrapping paper packaging, and then wrapped into a transparent plastic bag. Outer layer is very strong triangle box, and tear-resistant bags. But hope you can understand, Even if it is a strong packaging can not resist the possible violence transport. Due to the particularity of the material, some wrinkles and the like do not affect the installation. Hope you can kind understand. NOTE: We Suggest you to Ask Help From Professor. (Adhesive process is not so simple as show in the picture,  the lack of professioal operation roast and scrape the consequence may be the edge of the sticker after some time off) Make sure the target location is clean enough. You'd better scrub the surface with alcohol or special Cleaning Agent for several times. If permitted,heat it with heat gun.  Please Focus the 4 Sides and Heat Up to Avoid Dropping. The First 60 mins, the Stickiness is Weak, After That, Will Be Trongest. Thank,you and have nice day :)
T**)
Jagged edges once applied
I did pic but does not load. I put this on my self. You don't need a heat gun just patience. Use lots of soap and water to move around. It will stick a little with the soap. It took me an hour and 15 min to do. It's an exact fit so if it's off on one side the sticker will hang out on rubber. Make sure it's even on glass. It will not stick together too bad if both ends touch. Use a credit card or flat plastic square to get water out or tinting wedge. After you get most of water out take a soft towel and dry and put in sun for 30 min.My only gripe is the sticker ends are jagged. This means you could catch an edge with a towell when your cleaning car. So no loose ends on towels. They should of made it an 8 th inch on sides to be smooth. I gave 4 stars due to edges. I Also am not sure about taking this into an auto car wash.
L**.
Not recommended
Looks great for about a week and start peeling from the edges. I had to remove it.Not recommended. Unless you want something looking good for a few days
D**O
Smaller then it appears.
The picture shows the whole roof top covered, but was not like that in reality.
L**E
Five Stars
Great !!!!!!! Really Nice !
W**P
Perfect decal for my cute new Mini...
This decal came out great but I actually got the full color version. THe price is very reasonable but it s not something to put on yourself. I had a automotive detailing shop do it for about 50 bucks and they said I could not have done this well at home. You need to wet it and apply using a hot air dryer. They also applied it in a hot room, raising the temp up to remove excess moisture. They seemed to know what they were doing and warned that if you don this at home without the proper drying it could go flying right off the car once you drive away.My advice take it to a detailing shop and don't pay more than $100. Some shops tried to charge me over $400 to install this $45 decal. Call around.
Trustpilot
1 month ago
3 weeks ago
