Size:R55 R56 (Gen2) | Color:Usa Flag About Install:Please note that before you install, make sure that the surface is clean and free of grease.After the installation is complete, be sure to bake with hot air gun (to soften the adhesive material, enhance the adsorption)No completion of these two steps, it is possible in a very short time, the sticker will lose its sticky.About Material:This Kind of Material PVC, Have Flexibility, There might be a little bit of change Depend on the WeatherSo the size may Have Litter Error of 1-2CM difference.About packaging:We will first use wrapping paper packaging, and then wrapped into a transparent plastic bag.Outer layer is very strong triangle box, and tear-resistant bags.But hope you can understand, Even if it is a strong packaging can not resist the possible violence transport.Due to the particularity of the material, some wrinkles and the like do not affect the installation.Hope you can kind understand.NOTE:We Suggest you to Ask Help From Professor.(Adhesive process is not so simple as show in the picture, the lack of professioal operation roast and scrapethe consequence may be the edge of the sticker after some time off)Make sure the target location is clean enough.You'd better scrub the surface with alcohol or specialCleaning Agent for several times.If permitted,heat it with heat gun. Please Focus the 4 Sides and Heat Up to Avoid Dropping.The First 60 mins, the Stickiness is Weak, After That, Will Be Trongest.Thank,you and have nice day :)
A**O
Jagged edges once applied
I did pic but does not load. I put this on my self. You don't need a heat gun just patience. Use lots of soap and water to move around. It will stick a little with the soap. It took me an hour and 15 min to do. It's an exact fit so if it's off on one side the sticker will hang out on rubber. Make sure it's even on glass. It will not stick together too bad if both ends touch. Use a credit card or flat plastic square to get water out or tinting wedge. After you get most of water out take a soft towel and dry and put in sun for 30 min.My only gripe is the sticker ends are jagged. This means you could catch an edge with a towell when your cleaning car. So no loose ends on towels. They should of made it an 8 th inch on sides to be smooth. I gave 4 stars due to edges. I Also am not sure about taking this into an auto car wash.
D**E
Takes forever to arrive from China
I installed this myself with no problem. Bought a spray bottle. Small amount of dish soap mixed with water. Cleaned the glass roof - then sprayed a LOT of soapy water on the glass roof. Put the decal face down on the hood, peeled it apart spraying the water just at the start. Then peeled the back all the way off. Liberally sprayed the back of the decal (Flag) with the soapy water then gently flipped it on the roof like you would flip a bed sheet. If it sticks, peel it up and spray MORE water. You can spray right on top because of the tiny holes. I did have to go from side to side like 10 times to center it but it only took about 4 minutes for each piece. I used the squeegee that came with it. Plus a cloth to dab the water. HERE's THE IMPORTANT STEP: I spent like 40 minutes with a hair dryer on high slowly going back and forth using the squeegee and rag to dry it. Repeatedly squishing the edges until they stuck. Not sure if I like it but it was a Christmas present from my daughter.
W**O
Good Quality!
I purchased the Checkerboard 2 piece sun roof. The quality is great, and the 2 pieces fit my sunroof perfect. It looks great on my MINI! It has been on my car for a couple of weeks now, and it is holding up good with no problems. You are able to see through it. It does help with the sunlight coming through the sunroof which I have been enjoying during our summer heat wave. The graphic is cosmetically a nice feature, and functional. (helps block hot sun light) We installed the sun roof graphic at the house. Be sure to clean your sunroof well and use a very small amount of soapy water when installing. The only negative I can say is it took a long time to receive my order, but I did order during Covid which has slowed everything down. I recommend this product!
B**1
This looks great and it makes the inside so much cooler
This is sized perfectly and the installation was easy. I will say it is definitely a two person job but it took about 15 minutes to do both windows. So happy with the look and a cooler cabin.
L**.
Not recommended
Looks great for about a week and start peeling from the edges. I had to remove it.Not recommended. Unless you want something looking good for a few days
M**L
Would not recommend…
Looked great but that lasted only one day. Durability is to be desired. I was driving down the highway and a truck threw up a rock from the road and it created a 4cm gash in the vinyl. It was on for 21 hours before falling apart.
W**T
Great item!
It was very easy to put on and I think it makes my mini pop!
U**N
Great fit
Great fit and went on well. Quality seems fine and it is standing up to Arizona sunshine.
S**.
Love it
This went on quite easy and looks great, I did it on my own but could really do with 2 people, had to cut a couple of edges as slightly over and didn't want it to lift.
Trustpilot
1 month ago
2 weeks ago
